High-pressure centrifugal fan like AP. Coupling by means of belts.

High-pressure centrifugal fan like AP. Coupling by means of belts.
Air flow
V = 380÷10.800 m3/h
Pt = 240÷1.870 kg/m2

Use: also for the suction of very dusty air.
The fans of this series are particularly suitable for pneumatie conveyances, in cement factories, in the air feeding of the cupolas, in foundries and in oil burners, in mills, in “pasta” factories, in chemical, metallurgical and iron industries where small capacities with medium and high pressures are required.

For temperatures of the transported fluid higher than 90° C up to 350° C a small heat stopping fan is splined to the shaft between support and scroll; besides the fan is painted with a special aluminium paint suitable for high temperatures.

ErP: these fans are covered by Directive 2009/125/EC. This law does not apply in the following cases:
- Operation in potentially explosive atmospheres (ATEX)
- Operation with high temperatures (fans designed with cooling fan)
- Operation with temperatures below -40°C
- Working in toxic, corrosive or abrasive enviroments (use of material such as AISI 304, AISI 316, manganese steels).
These series are centrifugal forward curved fans and therefore expected Ntarget = 49 (Reg. UE N.327/2011).
ErP calculations take into account efficiency IE3 motors conforming to IEC 60034-30.
Please note that in the case of specific ratio >1,11 the Directive 2009/125/CE is applied, but these fans are not subject to the constraints of energy efficiency that it impose and therefore neither to the verification of these parameters.

Air flow -m3/min
Inlet pressure -kg/m2
Outlet pressure -kg/m2
Engine installed -poles
Installed power KW
Rotation speed round/min
Limit speed round/min
Fluid type
Inlet flange mm
Outlet flange xmm
Weight without engine Kg
GD2 Kgm2

General notes: