High-pressure centrifugal fan like APR. Coupling by means of belts.
V = 780÷800 m3/h
Pt = 430÷70 kg/m2
Use: for the suction of clean and dusty air. These types of high pressure fans are characterized by a high output with saving of electric power as they have a special fan wheel with reversed blades (negative) assembled.
These types of fans are particularly suitable for pneumatic conveyances, in cement factories, in the air feeding fo the cupolas in foundries and in oil burners, in the mills, in ?pasta? factories, in chemical, metallurgical and iron industries where small capacities with medium and high pressures are required.
For temperatures of the transported fluid higher than 90? C up to 350? C a small heat stopping fan is splined to the shaft between support and scroll; besides the fan is painted with a special aluminium paint suitable for high temperatures.
ErP: these fans are covered by Directive 2009/125/EC. This law does not apply in the following cases:
- Operation in potentially explosive atmospheres (ATEX)
- Operation with high temperatures (fans designed with cooling fan)
- Operation with temperatures below -40°C
- Working in toxic, corrosive or abrasive enviroments (use of material such as AISI 304, AISI 316, manganese steels).
These series are centrifugal backward curved fans and therefore expected Ntarget = 61 (Reg. UE N.327/2011).
ErP calculations take into account efficiency IE2 motors conforming to IEC 60034-30.
Please note that in the case of specific ratio >1,11 the Directive 2009/125/CE is applied, but these fans are not subject to the constraints of energy efficiency that it impose and therefore neither to the verification of these parameters.
|Weight without engine||Kg|